Clarke STRONG-ARM CSA12F 운영 및 유지보수 지침 매뉴얼 - 페이지 10
{카테고리_이름} Clarke STRONG-ARM CSA12F에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke STRONG-ARM CSA12F 17 페이지. 12 tonne hydraulic press
Clarke STRONG-ARM CSA12F에 대해서도 마찬가지입니다: 운영 및 유지보수 지침 매뉴얼 (17 페이지)
페이지 인쇄
• Check the hydraulic connections for leaks. Replace or properly repair any
damaged or leaking hydraulic components before using. In the event of
leaking seals, oil can be topped up via the plug on the end of the pump. Oil
should be level with the bottom of the hole. If necessary top up with CLARKE
hydraulic oil, Part No. 3050830. This task is carried out with the ram fully
retracted.
• If any rust is apparent it must be removed completely and the paint restored.
DE-COMMISSIONING PRODUCT
Should the product become completely unserviceable and require disposal,
draw off the oil into an approved container and dispose of the product and
the oil according to local regulations.
TROUBLESHOOTING
Problem
Pump unit will not work
Pump will not produce
pressure
Pump feels hesitant
under load
Pump will not lower
completely
Pump will not deliver
pressure
Pump feels hesitant
under load
Pump will not lower
completely
ACCESSORIES
7-piece mandrell (adaptor) kit for CSA12F Press: part no 7615060.
(Also listed as items 14 & 34 -39 on the parts list (pages 12 & 13).
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Probable Cause
Dirt on valve seat/warn
seals
Air-lock
Reservoir could be over-
filled or have low oil level.
Pump cup seal could be
worn out.
Air-lock
10
Remedy
Bleed pump unit or have
unit overhauled with new
seals
Open the release valve
and remove the oil filler
plug. Pump the handle a
couple of full strokes and
close the release valve.
Replace the filler plug.
Check oil level by
removing the filler plug
and topping up to the
correct level.
Have the cup seal
replaced.
Release air by removing
the filler plug