Zanussi ZBB 6286 지침 책자 - 페이지 14

{카테고리_이름} Zanussi ZBB 6286에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZBB 6286 32 페이지. Zanussi washer dryer brochure
Zanussi ZBB 6286에 대해서도 마찬가지입니다: 사양 (5 페이지), 지침 책자 (20 페이지), 사양 (7 페이지)

페이지 인쇄

Open the appliance door and the furniture door at

90°. Insert the small square (Hb) into guide (Ha).

Put together the appliance door and the furniture

door and mark the holes as indicated in the figure. .

Remove the brackets and mark a distance of 8 mm

from the outer edge of the door where the nail must

be fitted (K).

Place the small square on the guide again and fix it

with the screws supplied.

Should the lining up of the furniture door be

necessary, use the clearance of slots.

At the end of operations, it is necessary to check if

the door of the furniture closes properly.

Fix cover (Hd) on guide (Hb) until it clips into place.

If the appliance is to be fitted laterally to the kitchen

unit, it will be sufficient to loosen the screws of the

little plates (E), move them as shown in Fig. and

then fasten them up again.

After having reversed the opening direction of

the doors check that all the screws are properly

tightened and that the magnetic seal adheres to

the cabinet. If the ambient temperature is cold

(i.e. in Winter), the gasket may not fit perfectly to

the cabinet. In that case, wait for the natural

fitting of the gasket or accelerate this process by

heating up the part involved with a normal

hairdrier.

8mm

PR167

8mm

PR168

PR167/1