Zanussi ZBB28441SA 사용자 설명서 - 페이지 20

{카테고리_이름} Zanussi ZBB28441SA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZBB28441SA 49 페이지. Zanussi zbb28441sa fridge-freezer user manual
Zanussi ZBB28441SA에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 사용자 설명서 (32 페이지), 사용자 설명서 (29 페이지), 빠른 시작 매뉴얼 (12 페이지)

페이지 인쇄

1. Replacing the Lamp

Problem

There is too much frost and

ice.

Water flows on the rear plate

of the refrigerator.

Water flows inside the refriger-

ator.

Water flows on the floor.

The temperature in the appli-

ance is too low/too high.

If the advice does not lead to the

desired result, contact the nearest

Authorised Service Centre.

Possible cause

The door is not closed cor-

rectly or the gasket is de-

formed/dirty.

The water drainage plug is

not correctly positioned.

Food products are not wrap-

ped properly.

Temperature is set incorrect-

ly.

During the automatic de-

frosting process, frost melts

on the rear plate.

The water outlet is clogged.

Food products prevent that

water flows into the water

collector.

The melting water outlet is

not connected to the evapo-

rative tray above the com-

pressor.

The temperature regulator is

not set correctly.

The door is not closed cor-

rectly.

The food products' tempera-

ture is too high.

Many food products are stor-

ed at the same time.

The thickness of the frost is

greater than 4-5 mm.

The door has been opened

often.

There is no cold air circula-

tion in the appliance.

REPLACING THE LAMP

Solution

Refer to "Closing the door".

Position the water drainage plug

in the correct way.

Wrap the food products better.

Refer to "Operation" .

This is correct.

Clean the water outlet.

Make sure that food products do

not touch the rear plate.

Attach the melting water outlet to

the evaporative tray.

Set a higher/lower temperature.

Refer to "Closing the door".

Let the food products tempera-

ture decrease to room tempera-

ture before storage.

Store less food products at the

same time.

Defrost the appliance.

Open the door only if necessary.

Make sure that there is cold air

circulation in the appliance.

CAUTION! Disconnect the plug from

the mains socket.