Clarke Strong-Arm GC0915 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke Strong-Arm GC0915에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Strong-Arm GC0915 17 페이지. 10 tonne hydraulic bench press

HYDRAULIC PUMP/RAM OPERATION

1. Before using the press, purge any

air from the system by opening

the release valve by turning it anti-

clockwise and pumping several

full strokes to eliminate any air

bubbles. Tight the release valve

before continuing.

2. Check all parts are secure and

correctly aligned before using the

press.

The press is now ready for use.

1. Position the bed at the desired height, so it will be as close as possible to

the ram when the workpiece is mounted on it.

Mandrels are available as an

adaptor kit, any of which may be

connected to the end of the ram

using the adaptor.

Alternatively, the basic ram pressure

cap can be fitted as shown. Secure

the pressure cap by tightening the

grub screw with a suitable hex key.

If one of the mandrels is required, the

adaptor must be fitted instead of the

pressure cap. Secure the adaptor by

tightening the grub screw with a

suitable hex key.

Select your mandrel depending

upon the size of the workpiece

bearing surface.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]