Zanussi ZFC 252-1 지침 책자 - 페이지 6

{카테고리_이름} Zanussi ZFC 252-1에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZFC 252-1 12 페이지. Refrigerator zfc202-1

Door reversibility

Unplug the appliance before performing the

following operations:

Carefully lay the appliance on its back.

Remove the foot (A-Fig. 3).

Remove the hinge (C) by unscrewing the screws (B).

Remove the stop catch (E) by unscrewing the screws

(D).

Slide the door out of the upper hinge.

Remove the upper hinge and ﬁt on the opposite side

(Fig. 4).

Reassemble the door, inserting the upper hinge pin

into the bushing on the door.

Unscrew the left foor and reﬁt on the opposite side.

Fit the stop catch (E) on the opposite side.

Fit the hinge (C) and foot (A) on the opposite side.

Change the position of the handle (Fig. 5).

The holes that are not used are to be masked with the

plastic plugs removed.

Attention

After completion of the door reversibility operation,

verify that the door gasket is adherent to the cabinet.

If the ambient temperature is cold (i.e. in Winter), the

gasket may not ﬁt perfectly to the cabinet. In that

case, wait for the natural ﬁtting of the gasket or

accelerate this process by heating up the part

involved with a normal hairdrier.

Before plugging in, ensure that the voltage and

frequency shown on the serial number plate

correspond to your domestic power supply.

Voltage can vary by 6% of the rated voltage.

For operation with different voltages, a suitably sized

auto-transformer must be used.

The technical data is indicated in the rating plate on the left side inside the appliance.

TECHNICAL SPECIFICATION

D473

D185

D162

Fig. 3

Fig. 4

Fig. 5