Zanussi ZFC 50/17 AL 지침 책자 - 페이지 4

{카테고리_이름} Zanussi ZFC 50/17 AL에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZFC 50/17 AL 16 페이지. Zanussi owners manual compact refrigerator freezer zfd 50/17 r, zfd 50/17 ral
Zanussi ZFC 50/17 AL에 대해서도 마찬가지입니다: 지침 책자 (19 페이지)

페이지 인쇄

CONSERVATION

In the interests of the Environment:

When disposing of your old fridge, freezer or fridge/

freezer.

Help to keep your country tidy – use authorised

disposal sites for your old appliances.

INSTALLATION

Warning

IF YOU ARE DISCARDING AN OLD

APPLIANCE THAT HAS A LOCK OR CATCH

ON THE DOOR, YOU MUST ENSURE THAT IT

IS MADE UNUSABLE TO PREVENT YOUNG

CHILDREN BEING TRAPPED INSIDE.

Depending upon the position you choose for your

appliance, you may wish to reverse the way in which

the door opens. To do this, refer to instructions on

"Door reversal directions" paragraph.

Positioning

This appliance is designed to operate in ambient

temperatures between 10 ° C (50 ° F) and 32 ° C (90 ° F).

It should be located in a dry atmosphere, out of direct

sunlight and away from extreme temperature e.g.

not next to a cooker or other sources of direct heat,

or in a very cold room e.g. an outhouse, where the

temperatures may fall below 10 ° C (50 ° F). If these

temperatures are exceeded i.e. colder or warmer,

then the appliance may not operate correctly.

You should also ensure that air can circulate freely

around the back and the top of the cabinet. There must

also be at least 100 mm (4") distance between the top of

the cabinet and any overhanging kitchen furniture

(Fig. 1-A). Ideally, the appliance should not be

positioned beneath overhanging furniture (Fig. 1-B).

NP005

There should also be a gap of 25 mm either side of

the appliance. Do not obstruct the space

underneath. The back of the cabinet may be placed

close to the wall but must not touch it. DO NOT

Fig. 1

For maximum efficiency:

Make sure that the appliance is cleaned properly.

Make sure that the door is closed properly.

Do not position the appliance near to sources of

heat.

Do not over-ﬁll your appliance, air MUST be

allowed to circulate.

install in places with restricted ventilation.

Adjust the level of the appliance by screwing out

the adjustable foot, or feet, at the bottom of the

cabinet using your ﬁngers or a spanner (see Fig. 2).

D200

Before using

Remove all securing tapes. Wash inside the appliance

with lukewarm water and a little bicarbonate of soda

(one teaspoonful to one quart of water). Do not use

soap or detergent as the smell might linger. Dry

thoroughly.

Rear spacers

The plastic bag containing all relevant

documentation also contains two spacers to be ﬁtted

into special holes in the back of the appliance.

Fit the spacers into the holes, taking care to ensure

that the arrow (A) is positioned as shown in Fig. 2a.

Then turn them through 45 ° (arrow (A) vertical)

until they lock into place.

45°

D060

Fig. 2

Fig. 2a