Clarke Woodworker 6462160 운영 및 유지 관리 지침 - 페이지 11

{카테고리_이름} Clarke Woodworker 6462160에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Woodworker 6462160 16 페이지.

Base plate

screws

Fig 4a

DUST EXTRACTION

The jigsaw is provided with a dust extraction facility, where a dust bag or

vacuum extractor may be connected to the rear of the machine. Please

note however, that this does not preclude the user from wearing a face mask

to prevent the inhalation of dust particles.

It is an EEC requirement that a dust extraction facility be provided on power

tools. However, due to the nature of the tool, some of the dust produced will

be forced into the surrounding atmosphere, and will not be collected.

MAINTENANCE

CLEANING

• Always inspect the tool before use, and ensure it is in top condition.

• Ensure all air vents are clear, (use compressed air to clean the

machine if possible).

• After use, clean all dust and wood chippings from the jigsaw.

• Make sure that the base plate is free from dirt and grease.

• The blade locating clip and support roller should be kept clean and

lightly oiled at regular intervals.

• Keep the handle clean and free from oil and grease.

• Resin and glue on the blade causes poor cutting results. Clean the

blade after use.

GENERAL MAINTENANCE

• Ensure all nuts, bolts and screws remain tight to ensure the jigsaw is

in safe working condition.

• Refer to your CLARKE dealer if internal maintenance is required.

• Check the power cable to ensure it is sound and free from cracks,

bare wires etc. Avoid using solvents when cleaning plastic parts,

most plastics are susceptible to damage from the various types of

commercial solvents.

Fig 4b