Zanussi ZI 7165 지침 책자 - 페이지 6

{카테고리_이름} Zanussi ZI 7165에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZI 7165 9 페이지. Zanussi refrigerator
Zanussi ZI 7165에 대해서도 마찬가지입니다: 지침 책자 (16 페이지), 지침 책자 (21 페이지), 지침 책자 (20 페이지)

페이지 인쇄

Position the runners (H) at the top and bottom of

the inside of the kitchen unit as shown in Fig. 7

and mark the position of the external holes.

After preparing the holes, screw the runners to

the kitchen unit door using 3.5x16 mm screws.

Open both the appliance door and that of the

kitchen unit to approx. 90 .

Place the little plates over the runners. Hold the

doors of the appliance and the unit together and

mark the holes.

Remove the little plates and make the holes with

a diam. of 2 mm. Replace the little plates over

the runners and screw in the screws provided

(3.5x16 mm).

For the alignment of the kitchen unit door, if

necessary, use the clearance size of the slotted

holes.

At the end of the procedure, check that the doors

of the appliance and the kitchen unit open

properly.

Electrical connection

Before plugging in, ensure that the voltage and

frequency shown on the serial number plate

correspond to your domestic power supply.

Voltage can vary by 6% of the rated voltage.

For operation with different voltages, a suitably

sized auto-transformer must be used.

The technical data is indicated in the rating plate on the left side inside the appliance.

TECHNICAL SPECIFICATION

D094

8mm

PR34

PR35

Fig. 7

Fig. 8

Fig. 9