Zanussi ZI 729 K 지침 책자 - 페이지 7

{카테고리_이름} Zanussi ZI 729 K에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZI 729 K 11 페이지.
Zanussi ZI 729 K에 대해서도 마찬가지입니다: 지침 책자 (17 페이지)

Open both the appliance door and that of the

Fig. 9

kitchen unit to approx. 90°. Place the little plates

8mm

over the runners. Hold the doors of the appli-

ance and the unit together and mark the holes.

PR34

Remove the little plates and make the holes

with a diam. of 2 mm. Replace the little platee

Fig. 10

over the runners and screw in the screws

provided (3.5x16 mm).

For the alignment of the kitchen unit door, if

necessary, use the clearance size of the slotted

holes. At the end of the procedure, check that

the doors of the appliance and the kitchen unit

open properly.

PR35

If the appliance is to be fitted laterally to the

Fig. 11

kitchen unit, it will be sufficient to loosen the

screws of the little plates (D), move them as

shown in Fig. 11 and then fasten them up again.

Fit the cover (E).

D734

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond

to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with

different voltages, a suitably sized auto-transformer must be used.

TECHNICAL SPECIFICATIONS

The technical data is indicated in the rating plate on the left side inside the appliance.