Zanussi ZO 25 N 지침 책자 - 페이지 9
{카테고리_이름} Zanussi ZO 25 N에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZO 25 N 20 페이지. Refrigerator freezer
Zanussi ZO 25 N에 대해서도 마찬가지입니다: 지침 책자 (24 페이지), 지침 책자 (24 페이지)
페이지 인쇄
Door reversibility
Unplug the appliance from the power supply before
carrying out the below-mentioned operations.
Remove the ventilation grill (D).
Unscrew the bottom hinge (E).
Remove the freezer door by releasing it from the
middle hinge (H).
Unscrew the middle hinge.
Remove the fridge door by releasing it from the top
hinge pin (A).
Remove the pin and the washer (A+B) from the top
hinge (C), then mount these on the opposite side, after
having removed the plugs which must be refitted on
the other side.
Refit the fridge door.
Replace the middle hinge to the left hand side.
Replace the freezer door.
Screw down the bottom hinge (E) on the opposite side
by using the screws previously removed.
Remove the plug (F) from the ventilation grill (D) and
replace it on the opposite side.
Re-assemble the ventilation grill (D).
Unscrew the handle. Refit it on the opposite side.
The doors can be aligned by adjusting both the middle
and top hinges.
The middle hinge can be adjusted horizontally, with
the help of a tool, after having slackened the two
screws.
The top hinge is adjusted by slackening the nut with a
10 mm spanner and then proceeding as shown in the
Figure.
Warning:
After having reversed the opening direction of the
doors check that all the screws are properly
tightened and that the magnetic seal adheres to the
cabinet. If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of the
gasket or accelerate this process by heating up the
part involved with a normal hairdrier.
E
F
D
F
D640
D736
D738
H
D405
Fig. 4
F
F
Fig. 5
C
B
A
Fig. 6
Fig. 7
9