Clarke Woodworker CPT600 운영 및 유지 관리 지침 - 페이지 11
{카테고리_이름} Clarke Woodworker CPT600에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Woodworker CPT600 18 페이지. Planer/thicknesser
Clarke Woodworker CPT600에 대해서도 마찬가지입니다: 운영 및 유지보수 매뉴얼 (18 페이지)
페이지 인쇄
All manuals and user guides at all-guides.com
First, ensure the machine is switched OFF and isolated from the mains supply.
1. Turn the cutter height adjuster so that it registers zero. i.e turn the knob
clockwise so that the depth of cut, registered on the scale, is zero.
1. Remove the Angle Fence.
2. Raise the Cutter Guard arm.
3. Turn the cutter block to reveal the four hex. socket head screws securing the
cutter blade, then carefully remove them.
4. Turn the cutter block by 180 degrees and repeat the process.
ALWAYS hone/replace cutter blades as a pair.
5. Replace in reverse order, and, using a straight edge, ensure the cutting edges
are level and exactly in line with the table when they are at 12 o'clock - see
Fig.7. Tighten the securing screws taking care not to overtighten or damage
the hex. sockets..
NOTE: It is recommended that sharpening is done professionally, using a jig, as
blades must be sharpened as a pair to ensure they are correctly balanced. This
avoids the possibility of vibration due to inbalanced cutters rotating at speed.
Periodically.
•
Wipe both the infeed and outfeed rollers with a damp cloth to remove all
traces of contaminants.
•
Wax the Thicknesser table frequently to ensure a smooth and reliable feed.
•
Inspect the Kickback pawls before each operation to ensure they are intact
and working properly. They should hang normally and loosely.
•
Remove the front cover - 3 dome head nuts, and lightly oil all pivots, linkages
and bearings with good quality machine oil. Ensure the enclosure and all
components are perfectly clean before replacing the cover.
Fig. 7
11