Zanussi ZRB 2520 SR 지침 책자 - 페이지 16

{카테고리_이름} Zanussi ZRB 2520 SR에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZRB 2520 SR 20 페이지.

Rear spacers

The plastic bag containing all relevant

documentation also contains two spacers to be fitted

into special holes in the back of the appliance.

Fit the spacers into the holes, taking care to ensure

that the arrow (A) is positioned as shown in the

diagram. Then turn them through 45° (arrow (A)

vertical) until they lock into place.

1. Disconnect from the electricity supply.

2. Remove all loose items, including food, store food

in a cool place.

3. Gently lay the fridge/freezer on its back with the

top held away from the floor by 5-8 cm (2-3

inches) of packing;

4. Remove the feet (2-3)

5. Remove bottom hinge (1).

6. Remove the freezer door by releasing it from the

middle hinge (H).

7. Unscrew the middle hinge.

8. Unscrew the 2 blanking plastic headed screws

from the opposite side.

9. Slide out the fridge door from pin (G),

unscrew the latter and then screw it down into the

hinge provided on the opposite side, after having

removed the small plugs from the top of the doors

which should then be fitted on the opposite side.

10.Refit the fridge door and replace the middle hinge

to the left hand side.

11.Refit the plastic headed blanking screws into the

holes left by the middle hinge.

12.Replace the door and bottom hinge (1) on the

opposite side.

13.Refit the feet (2-3) on the opposite side.

Attention

After completion of the door reversing operation,

check that the door gasket adheres to the cabinet. If

the ambient temperature is cold (i.e. in Winter), the

gasket may not fit perfectly to the cabinet. In that

case, wait for the natural fitting of the gasket or

accelerate this process by heating up the part

involved with a normal hairdryer on a low setting.