Clarke Woodworker CPT800 운영 및 유지보수 매뉴얼 - 페이지 10
{카테고리_이름} Clarke Woodworker CPT800에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Woodworker CPT800 18 페이지. Planer/thicknesser
Clarke Woodworker CPT800에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (18 페이지)
페이지 인쇄
A. Thicknessing
1.
Lower the Thicknessing table sufficiently for the workpiece to be inserted
beneath the cutter blade, ensuring the blade is at 6 o'clock. Work enters
from the left and exits at the right of the machine,
2.
Raise the table until there is slight resistance. i.e. the work just touches the blade.
3.
Withdraw the workpiece, then wind the table upwards - turn clockwise, using
the Raise/Lower Table knob, to the appropriate cutting depth, noting that
one turn is equivalent to 3mm. Do not exceed 2mm depth of cut as this could
cause kickback, and/or damage to the components or overheating of the
motor.
Note: It is advisable when working with rough or warped wood to make very small
depths of cut to begin with - 1mm should be sufficient.
4.
Support the workpiece at the desired height, so that it is horizontal and feed it
into the cutter, from the left hand side of the machine. The rollers will
automatically feed the work past the kick-back pawls and into the cutter
blade. Ensure it is well supported at the outlet side
DO NOT remove chips or shavings from the table until the machine has stopped
completely and is isolated from thre mains supply.
NOTE:
1.
The workpiece should always be 2-3 inches longer than the finished length as
the ends tend to be uneven.
2.
The table should be lubricated with wax, frequently to ensure smooth operation.
MAINTENANCE
Always disconnect the machine from the mains supply before cleaning or
performing maintenance tasks.
This product is designed to operate with minimum of maintenance, however, as
with all power tools, cleanliness is essential in ensuring work is carried out to a
satisfactory standard. Always keep the table free of shavings/dust etc., and clean
the machine thoroughly after use. Use a low pressure air supply to blow dust from
air vents and other parts wherever possible.
Apply a thin film of wax to the table periodically. This will help keep the table
clean and allow workpieces to slide more easily.
Do not use solvents to clean the machine as this could damage plastic
components.
Cutter Blade Removal
Cutter blades will require sharpening or replacing. Care should be taken at all
times when handling them, they are very sharp, even when appearing to be dull.
Blades must always be fitted as a pair, and must be of the same type, only fit blades
recommended by the Clarke International.
10