Zanussi ZRB34315WA 사용자 설명서 - 페이지 13
{카테고리_이름} Zanussi ZRB34315WA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZRB34315WA 16 페이지.
페이지 인쇄As the colours of the wires in the mains lead of
this appliance may not correspond with the col-
oured markings identifying the terminals in your
plug, proceed as follows:
1. Connect the wire coloured green and yel-
low to the terminal marked either with the
letter "E" or by the earth symbol
oured green and yellow.
2. Connect the wire coloured blue to the ter-
minal either marked with the letter "N" or
coloured black.
3. Connect the wire coloured brown to the
terminal either marked with the "L" or col-
oured red.
4. Check that no cut, or stray strands of wire
is present and the cord clamp
over the outer sheath.
5. Make sure the electricity supply voltage is
the same as that indicated on the appliance
rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug
2
fitted
. In the event of having to change the
fuse in the plug supplied, a 13 amp ASTA ap-
proved (BS 1362) fuse must be used.
Warning! A cut off plug inserted into a 13
amp socket is a serious safety (shock)
hazard. Ensure that it is disposed of safely.
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door, do
these steps:
• Open the door and empty the shelves
• Unscrew the screws of the upper hinge. (1)
• Remove the door from the middle hinge pivot.
(2)
• Place the cover of the upper hinge into the
holes on the opposite side.
• Screw off the screws of the middle hinge (3)
www.zanussi.com
or col-
• Remove the plugs on the upper side of both
doors and move them to the other side.
• Remove the lower door from the lower hinge
pivot. (4)
4
is secure
• Screw off the pivot of the lower hinge (5) and
screw the lower hinge pivot (6) into the left
drill of the lower hinge.
• Screw off the screws of the lower hinge and
remove the hinge. (8)
• Screw off the lower cover plugs and screw
them into the hole on the opposite side. (7)
• Put the lower hinge on the opposite side and
fix it with the screws. (8)
1
2
4
6
5
13