Zanussi ZRB634FW 사용자 설명서 - 페이지 8

{카테고리_이름} Zanussi ZRB634FW에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZRB634FW 12 페이지. Fridge freezer
Zanussi ZRB634FW에 대해서도 마찬가지입니다: 사용자 설명서 (13 페이지), 사용자 설명서 (16 페이지)

Zanussi ZRB634FW 사용자 설명서
Problem
Water flows on the ground.
There is too much frost and ice.
The temperature in the appliance
is too low.
The temperature in the appliance
is too high.
The temperature in the refrigera-
tion is too high.
The temperature in the freezer is
too high.
The appliance does not operate. The appliance is switched off.
The lamp does not work.
If your appliance is still not working properly after making
the above checks, contact the After Sales Centre.
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
8
Possible cause
The melting water outlet does not flow
in the evaporative tray above the com-
pressor.
Products are not wrapped properly.
The door is not closed correctly.
The Temperature regulator may be set
incorrectly.
The Temperature regulator may be set
incorrectly.
The Temperature regulator may be set
incorrectly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the same
time.
There is no cold air circulation in the
appliance.
Products are too near to each other.
The mains plug is not connected to the
mains socket correctly.
The appliance has no power. There is
no voltage in the mains socket.
The lamp is defective.
Attach the melting water outlet to the
evaporative tray.
Wrap the products better.
Refer to "Closing the door".
Set a higher temperature.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature decrease to
room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circula-
tion in the appliance.
Store products so that there is cold air
circulation.
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appliance
to the mains socket. Contact a qualified
electrician.
Refer to "Replacing the lamp".
1. Remove the screw
from the lamp cov-
er.
2. Pull outwards the
hook of the lamp
cover.
3. Remove the lamp
cover.
4. Replace the lamp with one of the same power (the
maximum power is shown on the light bulb cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
Solution
1
2
3