Zanussi ZU 9145 지침 책자 - 페이지 9

{카테고리_이름} Zanussi ZU 9145에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZU 9145 11 페이지.

페이지 인쇄

1. Technical Specifications

This appliance complies with the following

E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modifications;

- 87/308 EEC of 02/06/87 (Radio Interference

Suppression Directive) and subsequent

modifications;

BUILDING-IN INSTRUCTIONS

Before carrying out any work, remove the plug from

the power socket.

Grid preparation

Remove the grid from the appliance pulling it towards

you with hands.

Right door opening:

Remove the left side (A) of the grid cutting it from the

rear (see figure, a).

Left door opening:

Remove the right side (B) of the grid cutting it from the

rear (see figure, b).

To reposition the grid on the appliance proceed as

follows:

Apply the grid to the base of the appliance by pushing

the clasps (a) until they click.

N.B. The grid is to be assembled after having fixed the

appliance in the niche with the brackets.

Door reversal

The appliance must be unplugged before starting

work. To reverse the opening direction of the door,

proceed as follows:

1. remove the top hinge (1) taking care not to let the

door fall;

2. remove the bottom door hinge (2).

3. take out the plugs (3) from the holes (F) and

reinsert them in the holes (F

4. refit the upper hinge (1) on the opposite side, on the

bottom (position A);

5. refit the door on the pin of the hinge (1) in position

6. insert the pin of the unscrewed bottom hinge (2) in

the upper hole (G) of the door, therefore fix the

hinge on the top in position B.

Important

After completion of the door reversal operation,

verify that the door gasket is sealing onto the

cabinet. If the ambient temperature is cold (i.e.

in Winter), the gasket may not fit perfectly to the

) on the opposite side;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modifications.

S.I.001

S.I.002

S.I.003

cabinet. In that case, wait for the natural

fitting of the gasket or accelerate this

process by heating up the part involved with

a normal hairdryer on a low setting.