Clarke X-Pro CAT205 운영 및 유지 관리 지침 - 페이지 6
{카테고리_이름} Clarke X-Pro CAT205에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke X-Pro CAT205 17 페이지. 1/4” air ratchet wrench
페이지 인쇄
Use only clean, dry, regulated compressed air as a power source.
Air compressors used with the tool must comply with the appropriate
European Community Safety Directives.
The air hose must be rated at least 150% of the maximum operating pressure of
the tool.
For optimum performance it is recommended that a 3/8" ID airline hose is
used.
Set the tool in the OFF position before connecting it to the air supply.
A build-up of moisture or oil in the air compressor will accelerate wear and
corrosion in the air tool. Ensure any moisture is drained from the compressor
daily and the inlet filter is kept clean.
If an unusually long air hose is required, (over 8 metres), the line pressure or the
hose inside diameter may need to be increased by up to 15 psi to maintain air
pressure at the tool.
Never exceed the maximum operating pressure for the air tool. It is
recommended that air pressure to this tool does not exceed 90 psi at the air
tool when running. Higher pressures and dirty air will shorten the life of the tool
due to faster wear and is a possible safety hazard.
Check hoses for wear or damage before use.
6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]