Clarke ZX-R Pro Series 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke ZX-R Pro Series에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke ZX-R Pro Series 17 페이지. 20v cordless multi function tool
Clarke ZX-R Pro Series에 대해서도 마찬가지입니다: 작동, 유지보수 및 사용 설명서 (8 페이지), 운영 및 유지보수 지침 매뉴얼 (9 페이지), 운영 및 유지보수 지침 매뉴얼 (17 페이지), 운영 및 유지보수 지침 매뉴얼 (13 페이지), 운영 및 유지보수 지침 매뉴얼 (17 페이지)

electrical wiring may exist. If this situation is unavoidable, disconnect all

fuses or circuit breakers feeding this worksite.

2. Use a metal detector to determine if there are gas or water pipes hidden in

the work area or call the local utility company for assistance before

beginning the operation. Striking or cutting into a gas line will result in

explosion. Water entering an electrical device may cause electrocution.

3. Keep hands away from cutting area. Do not reach under the material

being cut. The proximity of the blade to your hand is hidden from your sight.

4. Do not use dull or damaged blades. Bent blades can break easily or cause

kickback.

5. Exercise caution when handling the accessories. The accessories are very

sharp.

6. Wear protective gloves when changing cutting accessories. Accessories

become hot after prolonged usage.

7. Limit the exposure time to vibration by taking frequent rest periods.

Vibration caused by the tool may be harmful to the hands and arms.

8. Before scraping, check the workpiece for nails. If found, either remove

them or set them well below intended finished surface. Striking a nail with

accessory edge could cause the tool to jump.

9. Do not wet sand with this tool. Water entering the motor housing is an

electrical shock hazard.

10. Never work in area which is wet or damp such as newly applied wallpaper.

There is an electrical shock hazard when working in such conditions with a

power tool and heating of the water caused by scraping action may

cause harmful vapours to be emitted from workpiece.

11. Always wear eye protection and a dust mask for dusty applications and

when sanding overhead. Sanding particles can be absorbed by your eyes

and inhaled easily and may cause health complications.

12. Use special precautions when sanding chemically pressure treated

lumber, lead-based paint, or any other material that may contain

carcinogens. A suitable breathing respirator and protective clothing must

be worn by persons entering the work area. The work area should be

sealed by plastic sheeting and persons not protected should be kept out

until work area is thoroughly cleaned.

13. Do not use sandpaper intended for larger sanding pads. Larger sandpaper

will extend beyond the sanding pad causing snagging, tearing of the

paper or kick-back. Extra paper extending beyond the sanding pad can

also cause cuts.

14. Pease keep these instructions in a safe place for future reference.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]