Zanussi ZOB140X 사용자 설명서 - 페이지 13
{카테고리_이름} Zanussi ZOB140X에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZOB140X 20 페이지.
Zanussi ZOB140X에 대해서도 마찬가지입니다: 사용자 설명서 (21 페이지), 사용자 설명서 (20 페이지)
페이지 인쇄
Close the oven door
3
halfway to the first
opening position.
Then pull forward and
remove the door from
its seat.
Release the locking
5
system to remove the
internal glass panel.
2
1
First lift carefully and
7
then remove the
glass panel.
Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is completed, install the
glass panel and the oven door. Do the above
steps in the opposite sequence.
Troubleshooting
WARNING!
Refer to Safety chapters.
www.zanussi.com
Put the door on a soft
4
cloth on a stable
surface.
90°
Turn the two
6
fasteners by 90° and
remove them from
their seats.
The screen-printing zone must face the inner
side of the door. Make sure that after the
installation the surface of the glass panel frame
on the screen-printing zones is not rough when
you touch it.
Make sure that you install the internal glass
panel in the seats correctly.
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise
to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
13