Zanussi ZOG10311 사용자 설명서 - 페이지 19
{카테고리_이름} Zanussi ZOG10311에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZOG10311 24 페이지.
페이지 인쇄
B
A
2. Release the screw (C), which keeps the
burner in position.
C
3. Carefully move the burner off the injector
support (D).
D
E
F
4. Slowly move it to the left side. Do not apply
force to the wire of the spark plug
connector (F) and to the thermocouple
conductor (E).
5. Release the burner injector (D) with a 7 mm
socket spanner and replace it with a
different one which is necessary for the type
of gas you use.
Refer to "Technical information" chapter.
6. Assemble the burner in a reverse sequence.
Replace the gas type sticker near the gas
supply ramp with the one related to the new gas
type.
The gas oven burner does not need any primary
gas regulation.
Make sure that the gas supply
pressure of the appliance obeys the
recommended values.
www.zanussi.com
If the supply gas pressure is
changeable or different from the
necessary pressure, you must fit an
applicable pressure adjuster on the
gas supply pipe.
Minimum level adjustment of the oven
burner
1. Disconnect the appliance from the
electricity.
2. Turn the knob for the gas control to the
minimum position and remove it.
3. Adjust the adjustment screw (A) with a thin-
bladed screwdriver.
Change of
the type of
gas
From natural gas
to liquid gas
From liquid gas
to natural gas
4. Attach the knob for the gas control.
5. Connect the appliance to the electricity.
WARNING!
Only put the mains plug into the
mains socket when all parts are
back into their initial position. There
is a risk of injury.
6. Light the gas oven burner.
Refer to "Daily use" chapter.
7. Set the knob for the gas control to the
maximum position and let the oven heat for
at least 10 minutes.
8. Turn the knob for the gas control from the
maximum to the minimum position.
A
Adjustment
of the adjust-
ment screw
Fully tighten the
adjustment
screw in.
Release the ad-
justment screw
approximately
1/3 of a turn.
19