Zanussi ZOP38903 사용자 설명서 - 페이지 20

{카테고리_이름} Zanussi ZOP38903에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZOP38903 24 페이지. Product manaul
Zanussi ZOP38903에 대해서도 마찬가지입니다: 사용자 설명서 (24 페이지), 사용자 설명서 (28 페이지)

페이지 인쇄

1 2

Make sure that you put the glass panels (1, 2

and 3) back in the correct sequence. The mid-

dle panel (2) has a decorative frame. The

screen-printing zone must face the inner side

of the door. Make sure that after the installation

the surface of the glass panel frame (2) on the

screen-printing zones is not rough when you

touch it.

What to do if...

Warning! Refer to the Safety chapters.

Problem

The oven does not heat up.

The oven lamp does not oper-

ate.

The oven does not heat up.

The fan does not operate. The

display shows

Possible cause

The appliance is deactivated.

The clock is not set.

The necessary settings are not

set.

The automatic switch-off is on.

The Child Lock is on.

The fuse in the fuse box is re-

leased.

The oven lamp is defective.

The demo mode is activated.

Make sure that you install the top panel in the

seats correctly.

Activate the appliance.

Set the clock.

Make sure that the settings are cor-

rect.

Refer to "Automatic switch-off".

Refer to "Deactivating the Child Lock".

Do a check of the fuse. If the fuse is

released more than one time, contact

a qualified electrician.

Replace the oven lamp.

1. Deactivate the appliance.

2. Press and hold the button

approximately two seconds. An

acoustic signal sounds.

3. Press and hold the buttons

and

acoustic signal sounds again and

the indicator goes out.

Remedy

for

at the same time until the