Zanussi ZOS78964XU 사용자 설명서 - 페이지 43

{카테고리_이름} Zanussi ZOS78964XU에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZOS78964XU 49 페이지.

페이지 인쇄

If the function: Descaling is not

performed in the correct way, the

display will show a message to repeat

it.

If the oven is humid or wet, wipe it out with a dry

cloth. Let the oven dry fully with the door open.

DESCALING REMINDER

There are two descaling reminders which remind

you to perform the function: Descaling. These

reminders activate each time you switch off the

appliance.

The soft reminder reminds and recommends you to

perform the descaling cycle.

The hard reminder obligates you to perform the

descaling.

If you do not descale the appliance

when the hard reminder is on, you

cannot use the steam functions.

You cannot disable the descaling

reminder.

STEAM GENERATION SYSTEM - RINSING

Remove all accessories.

Select the function from the menu: Cleaning. The

user interface will guide you through the procedure.

The duration of the function is around 30 minutes.

The light in this function is off.

1. Put the baking tray on the first shelf position.

2. Press

3. Fill the water drawer with fresh water to the

maximum level until the acoustic signal sounds

or the display shows the message.

4. Press

Remove the baking tray after the end of the

procedure.

TANK EMPTYING

Remove all accessories.

The cleaning function removes the residual water

from the water drawer. Use the function after the

steam cooking function.

Select the function from the menu: Cleaning. The

user interface will guide you through the procedure.

The duration of the function is around 6 minutes.

The light in this function is off.

1. Put the baking tray on the first shelf position.

2. Press

Remove the baking tray after the end of the

procedure.

REMOVING AND INSTALLING THE DOOR

You can remove the door and the internal glass

panels to clean it. The number of glass panels is

different for different models.

WARNING! The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A) on the two

door hinges.

3. Close the oven door to the first opening

position (approximately 70° angle).

4. Hold the door with one hand on each side and

pull it away from the oven at an upwards angle.

5. Put the door with the outer side down on a soft

cloth on a stable surface.

6. Hold the door trim (B) on the top edge of the

door at the two sides and push inwards to

release the clip seal.

7. Pull the door trim to the front to remove it.

8. Hold the door glass panels on their top edge

one by one and pull them up out of the guide.

9. Clean the glass panel with water and soap. Dry

the glass panel carefully.

When the cleaning is completed, do the above

steps in the opposite sequence. Install the smaller

panel first, then the larger and the door.