Zanussi AquaCycle 1000 지침 책자 - 페이지 17

{카테고리_이름} Zanussi AquaCycle 1000에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi AquaCycle 1000 20 페이지. Washing machine f1000

페이지 인쇄

Drain filter

The drain filter collects threads and small objects

inadvertently left in the laundry. Check regularly that

the filter is clean.

Open the filter door.

Place a container under the filter and unscrew it.

Pull out the filter.

Clean the filter under a running tap, then refit it,

screwing it fully in.

Water inlet filter

If you notice that the machine is taking longer to fill,

check that the filter in the water inlet hose are not

blocked.

Turn off the water tap.

Unscrew the hose from the tap.

Clean the filter with a stiff brush.

Screw the hose back onto the tap.

Emergency emptying out

If the water is not discharged (drain filter is blocked,

filter or drain hose are clogged), proceed as follows

to empty out the machine:

• pull out the plug from the power socket;

• close the water tap;

• if necessary, wait until the water has cooled down;

• place a bowl on the floor under the filter;

• slightly loosen the filter to let the water come out

slowly;

• at the end screw the filter again.

The dangers of freezing

If the machine is installed in a place where the

temperature could drop below 0°C, proceed as

follows:

• Close the water tap and unscrew the water inlet

hose from the tap.

• Place the end of the drain hose and that of the inlet

hose in a bowl placed on the floor.

• Select programme DRAIN and run it until the

machine stops.

• Switch the machine OFF by depressing the

ON/OFF button.

• Screw the water inlet hose back on and put the

drain hose back in its place.

By doing this, any water remaining in the machine is

removed, avoiding the formation of ice and,

consequently, breakage of the affected parts.

When you use the machine again, make sure that

the ambient temperature is above 0°C.