Zanussi FA1035E 사용자 설명서 - 페이지 7

{카테고리_이름} Zanussi FA1035E에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi FA1035E 28 페이지. Washing machine fa835e

페이지 인쇄

Installation

Transit security bars

Before starting the machine up, the transport

security bars must be removed as follows:

You are advised to keep all the transport security

bars. In case the appliance has to be transported

again.

P0287

P0018

AL009

P0001

4. Place the machine in an upright position and

remove the three plastic bolts.

5. Plug the 3 holes with the plastic plugs which you

can find in the envelope containing the instruction

booklet.

1. Unscrew and remove

the three rear screws

by means of a key.

2. Lean the appliance

back on the rear and

fit one of the

polystyrene angles

between the appliance

and the floor.

Make sure the hoses

are not squashed.

3. Carefully remove the

plastic bags on the left

and the right, pulling

them to the centre of

the appliance

P0002

Hydraulic connection

There should be a COLD WATER tap near the

washing machine with a screwing on connection

pipe of 3/4 gas for the water supply, a sink, a wash

basin or a drainage system in the wall.

Previously check if:

— it is not a hot water tap.

— the running water is clean. If not, run off a

reasonable amount of water to flush out any

debris that may have collected in the pipes.

Have the permanent drainage system in the wall

checked by a plumber.

P0021

fixed to the wall by means of an opening on the upper

part and that way the hose does not move and its

falling is avoided.

1. Carefully screw the

pipe to the tap taking

care not to damage the

screwdrive and fix the

nut well on to the end in

order to avoid leaking.

2. If necessary turn the

hose adequately by

unscrewing the nut at the

rear of the appliance.

Now tighten the nut anew

to avoid leaks. (Open the

tap and assure that it

does not leak and close

it again.)

3. Place the discharging

hose in a washbasin or

sink with the aid of the

bent piece delivered

separately. The bent

piece has to be entered

into the tube's mouth in

order to assure the

support. Aforesaid piece

allows the hose to be