Zanussi FAE625 사용자 설명서 - 페이지 10

{카테고리_이름} Zanussi FAE625에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi FAE625 28 페이지. Washing machine fae 625

Use

Control panel

1. Detergent dispenser drawer
Programme option buttons
Depending on the programme, different option
buttons can be combined.
When these buttons are pressed, the corresponding
lights come on. When they are pressed again, the
lights go off.
If an incompatible option with the selected
programme has been chosen, the corresponding
light flashes for about 2 seconds.
The option buttons:
NO SPIN or
RINSE HOLD;
STAIN and
SUPER RINSE
must be selected after the required programme has
been chosen, by turning the programme selector
(see section 9) and before starting the machine, by
pressing button
START / PAUSE.
2.
NO SPIN or
By pressing this button you have the possibility of
choosing between the following options:
NO SPIN: by selecting this option all the
spinning phases are turned off. To be used for
extremely delicate items.
RINSE HOLD (no-wrinkle): by selecting this
option the water of the last rinse is not drained.
When the programme has finished the light
goes on. Before opening the door the water must be
drained.
If both lights (
NO SPIN and
are not illuminated the programme will run without
either
NO SPIN or
RINSE HOLD
END
RINSE HOLD)
RINSE HOLD.
3.
STAIN button
The STAIN option is recommended for heavily
soiled or stained laundry that require the use of stain
remover. This option is available for COTTON and
SYNTHETIC programmes and with temperatures
over 40º. By selecting this button the machine will
extend the main wash with time optimised stain
action phase. The washing phase increases by 5
minutes and the stain remover must be poured into
the PREWASH compartment marked
have selected a programme with STAIN).
WARNING: It is not possible to select STAIN option
with programmes with PREWASH.
4.
SUPER RINSE button
Can be used with all programmes, except wool.
The machine will add 2 rinses to the selected
programme.
This option is recommended for people who are
allergic to detergents and in areas where the water
is very soft.
5.
START / PAUSE button
After selecting the required programme, by the
programme selector (see section 9), press this
button to start the machine; the corresponding light
stops flashing and will keep lighting until the
programme finishes.
To interrupt the running programme, depress
START / PAUSE button: the corresponding
light starts to flash.
To restart the programme from the point at which it
was interrupted, press
again.
10
(if you
START / PAUSE button