Zanussi FCS 920 C 사용자 설명서 - 페이지 18

{카테고리_이름} Zanussi FCS 920 C에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi FCS 920 C 48 페이지.

페이지 인쇄

Return machine to it's upright position and remove the

power supply cable and the draining and inlet hose

from the hose holders on the rear of the appliance.

With a suitable spanner unscrew and remove the three

screws and their spacers on machine's rear.

Positioning

Install the machine on a flat hard floor. Make sure that air

circulation around the machine is not impeded by carpets,

rugs etc. Check that the machine does not touch the wall

or furniture. Level the washing machine by raising or low-

ering the two front feet. If necessary, check the setting with

a spirit level. Any necessary adjustment can be made with

a spanner. Accurate levelling prevents vibration, noise and

displacement of the machine during operation.

The three holes must then

be plugged with the plastic

plug caps supplied in the

bag containing the in-

struction booklet, which

can be found inside the

drum.

Caution! Never place cardboard, wood or similar

materials under the machine to compensate for any

unevenness in the floor.

Water inlet

Warning! This appliance must be connected to a

cold water supply

Caution! Before connecting up the appliance to new

pipework or to pipework that has not been used for

some time, run off a reasonable amount of water to flush

out any debris that may have collected

Caution! Do not use the hose from your previous

appliance to connect to water supply.

Connect the hose to a tap

with a 3/4" thread. Always

use the hose supplied with

the appliance.

The inlet hose must not be lengthened. If it is too short

and you do not wish to move the tap, you will have to pur-

If necessary use the sup-

plied restrictor.

The machine end of the in-

let hose can be turned in

any direction. Set the hose

correctly by loosening the

ring nut. After positioning

the inlet hose, be sure to

tighten the ring nut again

to prevent leaks.