Zanussi FJ 1200 지침 책자 - 페이지 5

{카테고리_이름} Zanussi FJ 1200에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi FJ 1200 22 페이지. Zanussi washing machine instruction manual
Zanussi FJ 1200에 대해서도 마찬가지입니다: 지침 책자 (25 페이지)

페이지 인쇄

INSTALLATION

Waiter drainage

If you intend the drain hose from the machine to empty

into a sink, make sure that the sink is empty and that the

plug hole is not blocked.

If the machine is permanently plumbed in, hook the end

of the hose into a standpipe installed for the purpose.

The standpipe must have an internal diameter of at least

40 mm (1 1/2") in order that there is an air gap between

the drain hose and the standpipe. Make sure, that it is

designed in such a way, that the end of the drain hose

cannot be covered with water.

3pin

VO)

=a f=

1600 mm min

ee mm max

P0376

Important

Before connecting up the machine to new pipework or to

pipework that has not been used for some time, run off a

reasonable amount of water to flush out any debris that

may have collected in the pipes.

Whether discharging into a sink or a standpipe check

that the end of the drain hose is neither too high not too

low. The top of the curve in the hose's end should be no

more than 90cm (35.4"), and no less than 60cm (23.6")

above floor level.

Levelling

Level the washing

ma-

chine

by loosening

tightening the feet. Accu-

rate levelling prevents vi-

bration,

noise and dis-

placement of the machine

during operation.

After

levelling the machine, se-

cure the feet by tightening

the ring nuts.

Some vibration is inevitable, especially if mounted on a

wooden floor.

Sprung wooden floors are particularly susceptible to

vibration.

For advice, consult a builder. If possible,

always place the machine on a solid floor.

Special conditions

If the floor is carpeted with a deep-pile carpet or covered

with crumbly or soft material, insert a rigid support base

under the feet to prevent noise, vibration or displace-

ment. The base should protrude a few centimetres

beyond the edges of the machine.

Warning

The machine

should NOT be placed on deep pile

carpeting.

Note

Please ensure that when the appliance is installed it is

easily accessible for the engineer in the event of a

breakdown.

All plumbing and electrical work required to install this

appliance must be carried out by competent persons or

qualified plumbers or electricians.