Zanussi FJD 1266 W 지침 책자 - 페이지 18

{카테고리_이름} Zanussi FJD 1266 W에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi FJD 1266 W 27 페이지. Zanussi instructrion manual compact washer fjd 1266 w, fjd 1466 w, fjd 1466 s
Zanussi FJD 1266 W에 대해서도 마찬가지입니다: 지침 책자 (27 페이지), 지침 책자 (27 페이지)

페이지 인쇄

If the filter is blocked and the machine is unable to drain

you will need to drain the water manually from the

machine at this stage. To do this, unhook the drain hose

from the standpipe or sink and hold the end of the hose

over a bowl on the floor. The water should drain by

gravity into the bowl. When the bowl is full, hook the

hose back up and empty the bowl. Repeat the procedure

until water stops flowing out.

Unscrew and remove the filter.

Clean carefully under a fast running tap.

Put the cap back on the emergency emptying hose,

place the latter back in its seat. Close the filter door.

Warning

When the appliance is in use and depending on the

programme selected there can be hot water in the filter.

Never remove the filter during a wash cycle, always

wait until the appliance has finished the cycle, and is

empty. When replacing the filter, ensure it is securely

retightened so as to stop leaks and young children being

able to remove it.

The water inlet filter

If your water is very hard or contains traces of lime

deposit, the water inlet filter may become clogged.

It is therefore a good idea to clean it from time to time.

Turn off the water tap. Unscrew the water inlet hose.

Clean the filter using a hard bristle brush.

Tighten up the inlet hose.

The dangers of freezing

If the machine is exposed to temperatures below 0°C,

certain precautions should be taken.

Turn off the water tap.

Unscrew the inlet hose.

Unhook the drain hose from the rear support and

position the end of this hose and that of the inlet

hoses in a bowl. Run the draining programme.

To do this:

Switch the machine on

Select a washing programme

Press the SKIP/RESET button three times

Press START/PAUSE button

Disconnect the appliance.

Screw the inlet hose and reposition the drain hose.

When you intend to start the machine up again,

make sure that the room temperature is above 0°C.