Zanussi FJE 1204 사용자 설명서 - 페이지 22

{카테고리_이름} Zanussi FJE 1204에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi FJE 1204 23 페이지. Washing machine fe 1004; fje 1204

페이지 인쇄

Something not working?

Problems which you can resolve yourself.

During machine operation it is possible that the light

the following lights start to flash:

: problem with the water supply

: problem with water draining

: door open

Once the problem has been eliminated, press the START/PAUSE button

all checks, the problem persists, contact your local Service Centre.

Problem

• The machine does not start up:

• The machine does not fill:

• The machine fills then empties

immediately:

• The machine does not empty

and/or does not spin:

• There is water on the floor:

• Unsatisfactory washing results:

• The machine vibrates or is noisy:

• The door will not open:

, the light of the START/PAUSE button

Possible cause

• The door is not firmly closed.

• The machine is not plugged in or there is no power

at the socket.

• The main fuse has blown.

• The START/PAUSE button has not been

depressed.

• The water tap is closed.

• The inlet hose is squashed or kinked.

• The filter in the inlet hose is blocked.

• The door is not properly closed.

• The end of the drain hose is too low. Refer to

relevant paragraph in "water drainage" section.

• The drain hose is squashed or kinked.

• The RINSE HOLD option has been selected.

• The drain filter is clogged.

• Too much detergent or unsuitable detergent

(creates too much foam) has been used.

• Check whether there are any leaks from one of the

inlet hose fittings. It is not always easy to see this

as the water runs down the hose; check to see if it

is damp.

• The drain hose is damaged.

• Too little detergent or unsuitable detergent has

been used.

• Stubborn stains have not been treated prior to

washing.

• The correct temperature was not selected.

• Excessive laundry load.

• The transit bolts and packing have not been

removed.

• The support feet have not been adjusted.

• The laundry is not evenly distributed in the drum.

• Maybe there is very little laundry in the drum.

• The programme is still running, the drum is

turning.

• The door lock has not yet released.

• The water level is above the bottom edge of the door.

• The machine is heating the water.

and one of

to restart the programme. If after