Zanussi FJR 1454 W 지침 책자 - 페이지 18

{카테고리_이름} Zanussi FJR 1454 W에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi FJR 1454 W 27 페이지. Zanussi instruction booklet washing machine fjr 1254 w, fjr 1454 w

페이지 인쇄

cover and remove it. Always keep a rag nearby to dry

up spillage of water when removing the cover.

Remove any objects from the pump impeller by

•

rotating it.

• Put the cap back on the emergency emptying hose and

place the latter back in its seat.

• Screw the pump cover fully in.

• Close the pump door.

Warning

When the appliance is in use and depending on the

programme selected there can be hot water in the pump.

Never remove the pump cover during a wash cycle,

always wait until the appliance has finished the cycle,

and is empty. When replacing the cover, ensure it is

securely retightened so as to stop leaks and young

children being able to remove it.

Cleaning the water inlet filter

If your water is very hard or contains traces of lime

deposit, the water inlet filter may become clogged.

It is therefore a good idea to clean it from time to time.

Turn off the water tap. Unscrew the water inlet hose.

Clean the filter using a hard bristle brush.

Tighten up the inlet hose.

The dangers of freezing

If the machine is exposed to temperatures below 0°C,

certain precautions should be taken.

Turn off the water tap.

Unscrew the inlet hose.

Place the end of the emergency emptying hose and

that of the inlet hose in a bowl placed on the floor

and let water drain out.

Screw the water inlet hose back on and reposition

the emergency emptying hose after having put the

cap on again.

When you intend to start the machine up again,

make sure that the room temperature is above 0°C.

Emergency emptying out

If the water is not discharged, proceed as follows to

empty out the machine:

• pull out the plug from the power socket;

• close the water tap;

• if necessary, wait until the water has cooled down;

• open the pump door;

• place a bowl on the floor and place the end of the

emergency emptying hose into the bowl. Remove its

cap. The water should drain by gravity into the bowl.

When the bowl is full, put the cap back on the hose.

Empty the bowl. Repeat the procedure until water

stops flowing out;

• clean the pump if necessary as previously described;

• replace the emergency emptying hose in its seat after

having plugged it;

• screw the pump cover again and close the door.

18 18