Zanussi FJS 1276 지침 책자 - 페이지 7

{카테고리_이름} Zanussi FJS 1276에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi FJS 1276 22 페이지. Washing machine
Zanussi FJS 1276에 대해서도 마찬가지입니다: 지침 책자 (23 페이지)

페이지 인쇄

Positioning

The appliance has two inlet hoses, hot and cold,

with female 3/4" BSP thread connectors. If this

connection is not compatible with the plumbing of

the existing installation, a variety of connectors are

available from good hardware stores and plumbers

merchants to suit most domestic plumbing. Any

alteration to your existing plumbing must be carried

out by a competent person, or qualified plumber.

Water inlet

The inlets on the back of the appliance are colour

coded, blue for cold and red for hot.

Before connecting the hoses be sure to fit the mesh

filters supplied as per diagram.

If only a cold water supply is available, connect the

two hoses to a cold water outlet by means of a «Y»

connection piece.

Installation should comply with local water authority

and building regulations' requirements.

The appliance must be given a separate cold water

supply and not be connected to a mixer tap, a

single outlet water heater or a booster pump. A

minimum water pressure of 48 kPa is required for

safe operation of the appliance.

If you cannot make the cold water connection direct

from the rising mains, you may be able to operate

the appliance from your cold water storage system.

There should be a minimum distance of 5.02m

(16

ft) between the appliance's inlet and the

bottom of the water storage tank.

There will be sufficient pressure for the hot water

supply, providing there is a minimun height of 2.74

metres (9 ft) between the bottom of the cold water

storage tank and the bottom of the hot water

cylinder.

Set the hoses correctly by loosening the ring nuts.

After positioning the inlet hoses, be sure to tighten

the ring nuts again to prevent leaks.

P0003

P0021