Zanussi FJS 1597 W 지침 책자 - 페이지 22

{카테고리_이름} Zanussi FJS 1597 W에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi FJS 1597 W 28 페이지. Zanussi instructrion manual front-load washer fjs 1197 w, fjs 1397 w, fjs 1597 w

페이지 인쇄

Unpacking

All transit bolts and packing must be removed

before using the appliance.

You are advised to keep all the packaging for re-use in

case the machine is to be transported again.

Using a spanner unscrew and remove the rear right bolt.

Lay the machine gently on its back, making sure that the

hoses are not squashed.

Remove the polystyrene block from the bottom of the

machine.

Carefully slide out the right polythene bag (1).

Repeat the operation for the left polythene bag (2).

Remove the polystyrene base.

Set the machine upright and remove the two remaining

bolts from the back.

Pull out the three plastic spacers from the holes into

which the bolts were fitted.

Plug the open holes with the plugs which you can find

at the back of the appliance.

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not

impeded by carpets, rugs etc. Check that the machine

does not touch the wall or other kitchen units.

Never place cardboard, wood or similar materials under

the machine to compensate for any unevenness in the

floor.

Your new machine has been designed to be permanently

plumbed in to your home's water supply and drainage

system. However, if this is not possible, it may be

connected to suitable existing taps with the drain hose

discharging into a sink.

P0255

P0234

P0256

The appliance has two inlet hoses, hot and cold, with

female 3/4" BSP thread connectors. If this connection is

not compatible with the plumbing of the existing

installation, a variety of connectors are available from

good hardware stores and plumbers merchants to suit

most domestic plumbing. Any alteration to your existing

plumbing must be carried out by a competent person, or

qualified plumber.

Installation on a Suspended Floor

Suspended wooden floors are particularly susceptible to

vibration. To help prevent vibration we recommend you

place a waterproof wood panel, at least 15 mm thick

under the appliance, secured to at least 2 floor beams

with screws. If possible install the appliance in one of

the corners of the room, where the floor is more stable.

P0233

P0020