Zanussi FJS 972 CV 지침 책자 - 페이지 6

{카테고리_이름} Zanussi FJS 972 CV에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi FJS 972 CV 20 페이지. Washing machine fjs 972 cv

All transit bolts and packing must be

removed before using the appliance.

You are advised to keep all transit devices so

that they can be refitted if the machine ever has

to be transported again.

1. Using a spanner, unscrew and remove the

rear right-hand bolt and lay the machine on

its back, taking care not to squash the hoses.

This can be avoided by placing one of the

corner packing pieces between the machine

and the floor.

2. Remove the polystyrene block from the

bottom of the machine and release the two

plastic bags by removing the adhesive strip.

3. Carefully remove the right-hand bag (1) then

the left-hand bag (2) by pulling them towards

the centre of the machine.

4. Set the machine upright and remove the two

remaining bolts from the back.

5. Pull out the three plastic spacers from the

holes into which the bolts were fitted.

6. Plug the open holes with the plugs which you

will find at the back of the appliance.

Install the machine on a flat hard floor.

Make sure that air circulation around the

machine is not impeded by carpets, rugs etc.

Check that the machine does not touch the wall

or other kitchen units.

Carefully level by screwing the adjustable feet in

or out. Never place cardboard, wood or similar

materials under the machine to compensate for

any unevenness in the floor.

INSTALLATION

P0255

P0234

P0256

P0850

P0233

P0020