Zanussi FL 1015 지침 책자 - 페이지 7

{카테고리_이름} Zanussi FL 1015에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi FL 1015 24 페이지. Washing machine fl 1015; fl 1008

Installation

All transit bolts and packing must be

removed before using the appliance.

You are advised to keep all transit devices so that

they can be refitted if the machine ever has to be

transported again.

1. Using a spanner, unscrew and remove the two

rear bottom screws. Slide out the two plastic pins.

Lay the machine on its back, taking care not to

squash the hoses. This can be avoided by

placing one of the corner packing pieces between

the machine and the floor.

2. Remove the polystyrene block from the bottom of

the machine and release the two plastic bags.

3. Very carefully slide out the left polythene bag,

removing it towards the right and then

downwards.

4. Very carefully slide out the right polythene bag,

removing it towards the left and then upwards.

5. Set the machine upright and remove the

remaining rear screw. Slide out the relevant pin.

6. Plug all the holes with the plugs which you will

find in the envelope containing the instruction

booklet.

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is

not impeded by carpets, rugs etc. Check that the

machine does not touch the wall or other kitchen

units.

Carefully level by screwing the adjustable feet in or

out. Never place cardboard, wood or similar

materials under the machine to compensate for any

unevenness in the floor.

Connect the water inlet hose supplied with the

machine to a tap with a 3/4" thread.

Do not use already employed hoses for water

connection.

The other end of the inlet hose which connects to the

machine can be turned in any direction. Simply

loosen the fitting, rotate the hose and retighten the

fitting, making sure there are no water leaks.