Clarke 2090901 운영 및 유지 관리 지침 - 페이지 8
{카테고리_이름} Clarke 2090901에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 2090901 20 페이지.
페이지 인쇄
PREPARATION FOR USE
The engine and compressor are supplied without oil inside, a small bottle is
provided in the box and must be added before use (approx 0.6l to the
engine and 0.4l to the pump).
A.Environmental
•
Ensure the compressor is sited on a firm level surface.
•
Ensure the environment is dry and dust free.
•
Ensure there is adequate ventilation for:
a) Air intake to compressor pump
b) Cooling for compressor pump
c) Engine exhaust gases.
B. Engine
•
Perform a visual check of components and check oil and fuel levels .
Refer to engine service manual.
C. Pump
•
Check oil level on the Dipstick - to level marked.
D. Fueling
Fill with unleaded petrol, according to the instructions within the engine manual.
•
Ensure the fuel tap is set to the required position.
•
Ensure The fuel hose and connectors are intact, in perfectly servicable
condition and there is no leakage.
Note : Always use a funnel to fill the fuel tank so as to avoid accidental spillage of
fuel. If fuel is spilled it must be removed from the unit and surrounding area, before
attempting to start the engine.
E. Receiver
•
Drain off any condensate, by opening the drain cock (see Fig. 1).
Remember to close the cock when completed.
NOTE: This should be carried out DAILY when the compressor is in constant use.
F. Air Hose & Air Tool
•
Attach the air hose to the outlet using an appropriate connector.
•
Attach the air tool/spray gun to the air hose...If using snap couplings, use
a whip end, available from your Clarke dealer.
- 8 -