Zanussi DE 6744 지침서 - 페이지 17

{카테고리_이름} Zanussi DE 6744에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi DE 6744 22 페이지. Dishwasher
Zanussi DE 6744에 대해서도 마찬가지입니다: 지침서 (29 페이지), 지침서 (28 페이지)

페이지 인쇄

Installation instructions

Any electrical and/or plumbing work required to install

this appliance should be carried out by a qualified

electrician and/or plumber or competent person.

Remove all packaging before positioning the machine.

If possible, position the machine next to a water tap and a

drain.

Fitting under a counter

(kitchen worktop or sink)

By removing the machine's worktop, you can install it under a

close fitting sink unit or a pre-existing top, providing the

dimensions of the recess correspond to those shown in the

picture.

Proceed as follows:

Remove the machine's worktop by unscrewing the two rear

retaining screws, pull from the front and slide out the rear

slots, lifting the worktop.

Insert the machine after adjusting height and levelling with the

adjustable feet. When inserting the machine, ensure that the

water inlet and drain hoses are not kinked or squashed.

If the dishwasher is later used as a free-standing appliance,

the original worktop must be re-mounted.

The plinth on free-standing appliances is not adjustable.

Levelling

Good levelling is essential for correct closure and sealing of

the door.

When the appliance is correctly levelled, the door will not catch

on either side of the cabinet.

If the door does not close correctly, loosen or tighten the

adjustable feet until the machine is perfectly level.

IN05

Water supply connections

This dishwasher may be fed with either hot (max. 50°) or cold

water. Nevertheless we advise you a cold water supply.

A hot water supply is not always efficient with very soiled

crockery as it shortens the washing programmes a lot.

The dishwasher must not be connected to open hot water

appliances or instantaneous water heaters.

The dishwasher is fitted with safety devices that prevent the

wash water returning into the drinking water system and

comply with the applicable plumbing regulations.

The water pressure must be within the limits given in the

technical specifications. Your local Water Authority will advise

you on the average mains pressure in your area.

The dishwasher features fill and drain hoses which can be

turned either to the left or the right to suit the installation.

The water inlet hose must not be kinked, crushed, or entangled

when it is being connected up.

Do not use, for connection, old hoses which have been

used in another appliance.

If the machine is connected to new pipes or pipes which have

not been used for a long time, you should run the water for a

few minutes before connecting the inlet hose.

Water inlet hose with safety valve

After connecting the double-walled water inlet hose, the safety

valve is next to the tap. Therefore the water inlet hose is only

under pressure while the water is running. If the water inlet

hose starts to leak during this operation, the safety valve cuts

off the running water.

Please take care when installing the water inlet hose:

- The distance between the bottom edge of the safety value

and the floor on which the dishwasher is standing must be at

least 30 cm:

- The electrical cable for the safety valve is in the double-

walled water inlet hose. Do not immerse the water inlet hose

or the safety valve in water.

- If water inlet hose or the safety valve is damaged, remove

the mains plug immediately.

- A water inlet hose with safety valve must only be replaced by

a specialist or by the consumer services department.

- Place the water inlet hose in such a way that it is never

higher than the bottom edge of the safety valve.

CS19