Zanussi ZDT4041 지침서 - 페이지 11

{카테고리_이름} Zanussi ZDT4041에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZDT4041 20 페이지.

Starting a washing programme

In this fully integrated appliance the controls are located on the

top of the door. When selecting a programme, the door needs

to be open.

1. Check that the baskets have been

loaded correctly and that the spray

arms can rotate freely

2. Turn on the water tap

3. Set and start of the programme

Turn the programme selector dial clockwise until the

letter of the programme you wish to select corresponds

with the programme marker (see "Washing programmes"

chart).

Depress the On/Off push button and close the door.

The machine will start.

4. Interrupting a washing programme

in progress

Interrupt a washing programme in progress ONLY if

it's absolutely necessary.

Attention! Hot steam may escape when the door is

opened. Open the door carefully.

Open the dishwasher door; the programme will stop.

Close the door; the programme will start from the point in

which it was interrupted.

5. End of the washing programme

The dishwasher will automatically stop.

Open the door and wait a few minutes before removing

the dishes; in this way they will be cooler and the drying

will be improved.

Switch off the dishwasher by pressing the On/Off push

button.

6. Unloading the dishwasher

Hot dishes are sensitive to knocks. The dishes should

therefore be allowed to cool down before removing from

the appliance.

Empty the lower basket first and then the upper one; this

will avoid water dripping from the upper basket onto the

dishes in the lower one.

Water may appear on the sides and door of the

dishwasher as the stainless steel will eventually become

cooler than the dishes.

When the washing programme has finished, it is

recommended that the dishwasher is unplugged and the

water tap turned off.