Zanussi ZDT8453 지침서 - 페이지 16
{카테고리_이름} Zanussi ZDT8453에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZDT8453 21 페이지.
페이지 인쇄Starting a washing programme
In this fully integrated appliance the controls are located on the
top of the door. When selecting a programme, the door needs
to be open.
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Press the On/Off push button
All the indicator lights of the programme selection push
buttons illuminate (setting mode).
4. Setting and starting the programme
a) To select a programme, press the programme push
button of the washing programme you wish to select
(see "Washing programmes" chart).
The corresponding indicator light remains illuminated
while the other programme push buttons indicator lights
turn off.
b) To select the delay start of the programme, press the
"delay start" option push button until the indicator light
corresponding to the chosen hours flashes (3, 6 or 9
hours).
The start of the programme or the countdown of the delay
start will occur only after the closure of the door, until this
moment you can modify the selection made.
Close the dishwasher door.
a) If delay start has not been setted, the programme will
start automatically.
b) If delay start has been setted, the countdown starts
automatically and will decrease with steps of 3 hours.
The opening of the door will not modify or interrupt the
countdown. Once the delay start has elapsed the
programme will start automatically.
5. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing programme in progress
ONLY if it's absolutely necessary
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
Interrupt a washing programme in progress
Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the point in
which it was interrupted.
Cancel a washing programme in progress
Open the dishwasher door.
Press simultaneously the function push buttons 2 and 3
for about 2 seconds, the indicator light of the push button
corresponding to the running programme starts flashing for
about 2 seconds.
After about 2 seconds the indicator lights of all the
programme push buttons will illuminate indicating that the
running programme has been cancelled and that the
machine has returned to setting mode.
It is now possible to select and start a new washing
programme. (If a new washing programme will be
selected, check that there is detergent in the detergent
dispenser).
6. To cancel a delay start in progress
Open the dishwasher door.
Press simultaneously the function push buttons 2 and 3
for about 2 seconds.
After about 2 seconds the indicator lights of all the
programme push buttons will illuminate indicating that the
delay start in progress has been cancelled and that the
machine has returned to setting mode.
With the cancelling of the delay start also the setted
programme has been cancelled.
Set the washing programme again.
7. End of the washing programme
The dishwasher will automatically stop and an audible
signal informs you of the end of the washing programme.
Hot steam may escape from the appliance when opening
the door immediately after the end of the programme,
therefore, open the door carefully.
The end of programme indicator light is illuminated.
Switch off the dishwasher by pressing the On/Off push
button.
8. Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
35