Zanussi ZSF2430 사용자 설명서 - 페이지 5

{카테고리_이름} Zanussi ZSF2430에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZSF2430 32 페이지.
Zanussi ZSF2430에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

Use of the appliance

Refer to the following instructions for each step of proce-

dure:

1. Make a check if the water softener level is correct for

the water hardness in your area. If necessary set the

water softener.

2. Fill the salt container with dishwasher salt.

3. Fill the rinse aid dispenser with rinse aid.

4. Load cutlery and dishes into the dishwasher.

Setting the water softener

The water softener removes minerals and salts from the

water supply. Minerals and salts can have bad effect on

the operation of the appliance.

Water hardness is measured in equivalent scales:

• German degrees (dH°).

• French degrees (°TH).

°dH

>24

22- 24

20- 22

18- 20

16- 18

13- 16

10- 13

7- 10

4- 7

< 4

1) No use of salt required.

Electronic adjustment

The water softener is set at the factory at level 5.

1. Press and hold the start/cancel button. Turn the pro-

gramme knob clockwise until the programme marker

agrees with the first washing programme on the con-

trol panel.

Water hardness

mmol/l

>4.2

3,9- 4,2

3,5- 3,9

3,2- 3,5

2,8- 3,2

2,3- 2,8

1,8- 2,3

1,2- 1,8

0.7- 1,2

< 0.7

5. Set the correct washing programme for the type of

load and soil.

6. Fill the detergent dispenser with the correct quantity

of detergent.

7. Start the washing programme.

If you use detergent tablets, refer to the chapter 'Use

of detergent'.

• mmol/l (millimol per litre - international unit for the

hardness of water).

• Clarke.

Adjust the water softener to the water hardness in your

area. If necessary, contact your local water authority.

°TH

Clarke

>40

39- 40

27- 29

35- 39

25- 27

32- 35

23- 25

28- 32

20- 23

23- 28

18- 23

13- 17

12- 18

7- 12

< 7

2. Release the start/cancel button when the on/off indi-

cator light and the start/cancel indicator light start to

flash.

– At the same time, the end indicator light flashes to

show the level of the water softener.

Example:

5 flashes, pause, 5 flashes, pause, etc... = level 5

3. Press the start/cancel button one time to increase the

water softener level by one step.

Water hardness setting

> 29

17-20

9- 13

5- 9

< 5