Zanussi ZSF2450 사용자 설명서 - 페이지 10

{카테고리_이름} Zanussi ZSF2450에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZSF2450 20 페이지. Product manaul
Zanussi ZSF2450에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지), 사용자 설명서 (20 페이지)

페이지 인쇄

Use of detergent tablets

Put the detergent tablet in the detergent dis-

penser (A).

Detergent tablets contain:

• detergent

• rinse aid

• other cleaning agents.

Do these steps to use detergent tablets:

1. Make sure that the detergent tablets are ap-

plicable for your water hardness. Refer to the

instructions from the manufacturer.

2. Set the lowest levels of water hardness and

rinse aid dosage.

Setting and starting a washing programme

Set the washing programme with the door

ajar. The washing programme only starts af-

ter you close the door. Until then it is possible to

modify the settings.

Do these steps to set and start a washing pro-

gramme:

1. Switch on the appliance.

2. Make sure that the appliance is in setting

mode.

3. Press one of the programme buttons. Refer

to the chapter 'Washing programmes'.

– The programme indicator light comes on.

– All other programme indicator lights go

off.

– The digital display shows in flashing the

programme duration.

– The phase indicator light for the washing

programme starts to flash.

4. Close the door.

It is not necessary to fill the salt container

and the rinse aid dispenser.

Do these steps when the drying results are

not satisfactory:

1. Fill the rinse aid dispenser with rinse aid.

2. Set the rinse aid dosage to position 2.

Do these steps to use the detergent powder

again:

1. Fill the salt container and the rinse aid dis-

penser.

2. Set the water softener to the highest level.

3. Do a washing programme without dishes.

4. Adjust the water softener. Refer to the chap-

ter 'Setting the water softener'.

5. Adjust the rinse aid dosage.

Different brands of detergent dissolve in

different times. Some detergent tablets do

not have the best cleaning results during short

washing programmes. Use long washing pro-

grammes when you use detergent tablets to fully

remove the detergent.

– The washing programme starts automati-

cally.

– The phase indicator light for the washing

programme is on.

When the washing programme operates,

you cannot change the programme. Cancel

the washing programme.

Warning! Only interrupt or cancel a washing

programme if necessary.

Caution! Open the door carefully. Hot

steam can come free.

Cancelling a washing programme

1. Press and hold function buttons B and C until

all the programme lights come on.

2. Release function buttons B and C to cancel

the washing programme.

At this time you can do these steps:

1. Switch off the appliance.