Zanussi ZSF2450S 사용자 설명서 - 페이지 11

{카테고리_이름} Zanussi ZSF2450S에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZSF2450S 16 페이지. Product manaul
Zanussi ZSF2450S에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)

페이지 인쇄

Problem

You cannot activate the appliance.

The programme does not start.

The appliance does not fill with water.

The appliance does not drain the water.

The anti-flood device is on.

After the checks are completed, activate the ap-

pliance. The programme continues from the

point of interruption.

If the problem occurs again, contact the Serv-

ice.

If other alarm codes appear, contact the Serv-

ice.

If the washing and drying results are not

satisfactory

Whitish streaks or bluish layers on

glasses and dishes

• The released quantity of rinse aid is too

much. Adjust the rinse aid selector to a lower

position.

• The quantity of detergent is too much.

Technical information

Dimensions

Electrical connection

Water supply pressure

Water supply

Capacity

www.zanussi.com

Make sure that the mains plug is connected to the mains

socket.

Make sure that there is not a damaged fuse in the fuse box.

Make sure that the appliance door is closed.

If the delay start is set, cancel the setting or wait for the end

of the countdown.

Make sure that the water tap is open.

Make sure that the pressure of the water supply is not too

low. For this information, contact your local water authority.

Make sure that the water tap is not clogged.

Make sure that the filter in the inlet hose is not clogged.

Make sure that the inlet hose has no kinks or bends.

Make sure that the sink spigot is not clogged.

Make sure that the drain hose has no kinks or bends.

Close the water tap and contact the Service.

Stains and dry water drops on glasses and

dishes

• The released quantity of rinse aid is not suffi-

• The quality of the detergent can be the

Dishes are wet

• The programme is without a drying phase or

• The rinse aid dispenser is empty.

• The quality of the rinse aid can be the cause.

Width / Height / Depth (mm)

Refer to the rating plate.

Voltage

Frequency

Min. / max. (bar / MPa)

Cold water or hot water

Place settings

Possible solution

cient. Adjust the rinse aid selector to a higher

position.

cause.

with a low temperature drying phase.

Refer to 'HINTS AND TIPS' for other pos-

sible causes.

545 / 447 / 480

220 - 240 V

50 Hz

(0.8 / 0.08 ) / (10 / 1.0 )

max. 60 °C