Zanussi ZSFN132W1 사용자 설명서 - 페이지 19
{카테고리_이름} Zanussi ZSFN132W1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZSFN132W1 25 페이지.
페이지 인쇄
Problem and alarm code
Malfunction of the wash pump or the drain
pump.
•
The indicator
termittently.
•
The light related to the start button
flashes continuously.
The temperature of the water inside the
appliance is too high or malfunction of the
temperature sensor occurred.
•
The indicator
termittently.
•
The light related to the start button
flashes continuously.
Technical malfunction of the appliance.
•
The indicator
termittently.
•
The light related to the start button
flashes continuously.
The level of water inside the appliance is
too high.
•
The indicator
termittently.
•
The light related to the start button
flashes continuously.
The appliance stops and starts more
times during operation.
The programme lasts too long.
Small leak from the appliance door.
The appliance door is difficult to close.
The appliance door opens during the
wash cycle.
Rattling/knocking sounds from inside the
appliance.
flashes 5 times in-
flashes 6 times in-
flashes 12 times in-
flashes 15 times in-
Possible cause and solution
•
Switch the appliance off and on.
•
Make sure that the temperature of the inlet water
does not exceed 60°C.
•
Switch the appliance off and on.
•
Switch the appliance off and on.
•
Switch the appliance off and on.
•
Make sure that the filters are clean.
•
Make sure that the outlet hose is installed at the
right height above the floor. Refer to the installation
instructions.
•
It is normal. It provides optimal cleaning results and
energy savings.
•
If the delayed start option is set, cancel the delay
setting or wait for the end of the countdown.
•
Refer to the consumption values table in the chapter
"Programmes".
•
The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
•
The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
•
The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
•
Parts of the tableware are protruding from the bas-
kets.
•
The AirDry function is activated. You can deactivate
the function. Refer to "Settings".
•
The tableware is not properly arranged in the bas-
kets. Refer to basket loading leaflet.
•
Make sure that the spray arms can rotate freely.
19