Zanussi ZSLN1211 사용자 설명서 - 페이지 4

{카테고리_이름} Zanussi ZSLN1211에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZSLN1211 28 페이지.
Zanussi ZSLN1211에 대해서도 마찬가지입니다: 사용자 설명서 (21 페이지)

페이지 인쇄

• If the appliance has ventilation openings in the base, they

must not be covered e.g. by a carpet.

• The appliance is to be connected to the water mains using

the new supplied hose-sets. Old hose sets must not be

reused.

2. SAFETY INSTRUCTIONS

2.1 Installation

WARNING!

Only a qualified person must install this

appliance.

• Remove all the packaging.

• Do not install or use a damaged

appliance.

• Follow the installation instructions supplied

with the appliance.

• Always take care when moving the

appliance as it is heavy. Always use safety

gloves and enclosed footwear.

• Do not install or use the appliance where

the temperature is less than 0 °C.

• Install the appliance in a safe and suitable

place that meets installation requirements.

• Do not use the appliance before installing

it in the built-in structure due to safety

manner.

2.2 Electrical connection

WARNING!

Risk of fire and electric shock.

• Warning: this appliance is designed to be

installed / connected to a grounding

connection in the building.

• Make sure that the parameters on the

rating plate are compatible with the

electrical ratings of the mains power

supply.

• Always use a correctly installed

shockproof socket.

• Do not use multi-plug adapters and

extension cables.

• Make sure not to cause damage to the

mains plug and to the mains cable. Should

the mains cable need to be replaced, this

ENGLISH

must be carried out by our Authorised

Service Centre.

• Connect the mains plug to the mains

socket only at the end of the installation.

Make sure that there is access to the

mains plug after the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• This appliance is fitted with a 13 A mains

plug. If it is necessary to change the mains

plug fuse, use only a 13 A ASTA (BS

1362) fuse (UK and Ireland only).

2.3 Water connection

• Do not cause damage to the water hoses.

• Before connection to new pipes, pipes not

used for a long time, where repair work

has been carried out or new devices fitted

(water meters, etc.), let the water flow until

it is clean and clear.

• Ensure that there are no visible water

leaks during and after the first use of the

appliance.

• If the water inlet hose is damaged,

immediately close the water tap and

disconnect the mains plug from the mains

socket. Contact the Authorised Service

Centre to replace the water inlet hose.

• Without electrical power, the water

protection system is not active. In this

case there is a risk of flooding.

• The water inlet hose has a safety valve

and a sheath with an inner mains cable.