Zanussi ZTM 6825 지침 책자 - 페이지 21

{카테고리_이름} Zanussi ZTM 6825에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZTM 6825 26 페이지.

Water outlet hose connection

The end of the drain hose can be connected in the

following ways:

1. To the sink outlet siphon, securing it if

necessary with a clip.

2. To a stand pipe provided with vent-hole,

minimum internal diameter 4 cm.

The waste connection must be at a height of

between 30 cm (minimum) and 100 cm (maximum)

from the bottom of the dishwasher.

The drain hose can face either to the right or left of

the dishwasher

Ensure the hose is not bent or squashed as this

could prevent or slow down the discharge of water.

If you use a drain hose extension it must be no

longer than 2 metres and its internal diameter must

be no smaller than the diameter of the hose

provided.

Likewise the internal diameter of the couplings

used for connections to the waste outlet must be

no smaller than the diameter of the hose provided.

The sink plug must not be in place when the

machine is draining as this could cause the

water to siphon back into the machine.

Before plugging the appliance into the wall socket,

make sure that:

1. The mains voltage corresponds to the voltage

given in the "Technical specifications".

2. The meter, fuses, mains power supply and wall

socket can all take the maximum load required.

Make sure that the socket and plug are

compatible without having to use any type of

adaptor. If necessary, have the domestic wiring

system socket replaced.

Safety standards require the appliance to be

earthed.

The manufacture accepts no liability for failure

to observe the above safety precautions.

This appliance complies with the following E.E.C. Directives:

- 73/23 of 19.2.73 (Low Voltage Directive) and subsequent modifications;

- 89/336 of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.

CS13

CS14

+ 2 m max

PWA04GB