Zanussi ZDG322 지침 책자 - 페이지 18

{카테고리_이름} Zanussi ZDG322에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZDG322 20 페이지. Gas hob zdg322

페이지 인쇄

Commissioning

When the hob has been fully installed it will be necessary

to check the minimum flame setting. To do this, follow

the procedure below.

Turn the gas tap to the MAX position and ignite.

Set the gas tap to the MIN flame position then turn

the control knob from MIN to MAX several times. If

the flame is unstable or is extinguished follow the

procedure below.

Procedure:

Re-ignite the burner and set to MIN.

Remove the control knob.

To adjust, use a thin bladed screwdriver and

turn the adjustment screw (see diagram) until

the flame is steady and does not extinguish,

when the knob is turned from MIN to MAX.

Repeat this procedure for all burners.

Pressure Testing

Remove left hand pan support and front left

burner cap and crown.

Fit manometer tube over the injector.

Turn on the burner gas supply and ignite

another burner.

The pressure reading should be nominally 20

mbar and must be between 17 mbar and 25

mbar.

Turn off the burner supplies.

Conversion from Natural Gas to LPG

IMPORTANT

The replacement/conversion of the gas hob should only

be undertaken by a competent person.

It is important to note that this model is designed for use

with natural gas but can be converted for use with butane

or propane gas providing the correct injectors are fitted.

The gas rate is adjusted to suit.

Method

•

Ensure that the gas taps are in the 'OFF' position

•

Isolate the hob from the electrical supply

•

Remove all pan supports, burner caps, rings, crowns

and control knobs.

•

With the aid of a 7mm box spanner the burner injectors

can then be unscrewed and replaced by the

appropriate LPG injectors.

Minimum adjustment screw

To adjust the gas rate

With the aid of a thin bladed screwdriver completely

tighten down the by pass adjustment screw. Upon

completion stick the replacement rating plate on the under

side of the hob.