Zanussi ZDG322 지침 책자 - 페이지 5

{카테고리_이름} Zanussi ZDG322에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZDG322 20 페이지. Gas hob zdg322

페이지 인쇄

Operation

Hob burners

The hob burner control knobs are situated on the hob front

panel. The symbols on the knobs mean that :

there is no gas supply

there is maximum gas supply / Ignition setting

there is minimum gas supply

To light a burner:

turn the relevant control knob anticlockwise to the

maximum position, then push it down to ignite the

burner;

then, check the flame is regular and adjust it as

required.

If you cannot light the flame even after several attempts,

check the "cap" and "crown" (see diagram - letter A

and B) are in the correct position.

To put the flame out, turn the knob to the symbol

When switching on the mains, after installation or

a power cut, it is quite normal for the spark

generator to be activated automatically.

To ensure maximum burner efficiency, you should only

use pots and pans with a flat bottom fitting the size of

the burner used (see table).

Burner

Large (rapid)

Small (auxiliary)

If you use a saucepan which is smaller than

the recommended size, the flame will spread

beyond the bottom of the vessel, causing the

handle to overheat.

Take care when frying food in hot oil or fat,

as the overheated splashes could easily ignite.

As soon as a liquid starts boiling, turn down the

flame so that it will barely keep the liquid

simmering.

If the control knobs become difficult to turn, please

contact your local Service Force Centre.

minimum

maximum

diameter

180 mm

260 mm

80 mm

160 mm

A - Burner cap

B - Burner crown

C - Ignition electrode