Zanussi ZDK320 사용자 설명서 - 페이지 11

{카테고리_이름} Zanussi ZDK320에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZDK320 40 페이지.

페이지 인쇄

eg. automatic line protecting cut-out, earth leakage

trips or fuse.

• None of a parts of the connection cable can not get a

temperature 90 °C. The blue neutral cable must be

connected to the terminal block label with "N". The

brown (or black) phase cable (fitted in the terminal

block contact marked with "L") must always be connec-

ted to the live phase.

Replacement of the connection cable

To replace the connection cable use only H05V2V2-F T90

or equivalent type. Make sure that the cable section is ap-

plicable to the voltage and the working temperature. The

yellow/green earth wire must be approximately 2 cm lon-

ger than the brown (or black) phase wire.

Assembly

min. 650 mm

If several 30 cm hobs are to be installed side by side into

the same cut out, an assembly kit including a support side

bracket and supplementary seals is available at our Serv-

ice Centres. The relevant installation instructions are sup-

plied within the kit package.

A — seal to remove

B — supplied brackets

Possibilities for insertion

Kitchen unit with door

The panel installed below the hob must be easy to remove

and let an easy access in case a technical assistance inter-

vention is necessary.

a) Removable panel

b) Space for connections

Kitchen unit with oven

490 mm

The hob recess dimensions must obey the indication and

the kitchen unit must be equipped with vents to let a con-

tinuous supply of air. The electrical connection of the hob

270 mm

and the oven must be installed separately for safety rea-

sons and to let easy remove oven from the unit.

MANUFACTURER:

ELECTROLUX ITALIA S.p.A.

C.so Lino Zanussi, 30

33080 PORCIA (PN) - ITALIA

30 mm

min 20 mm

60 mm

(max 150 mm)

50 cm

360 cm

120 cm

180 cm 2