Zanussi ZEV6332FBA 사용자 설명서 - 페이지 10

{카테고리_이름} Zanussi ZEV6332FBA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZEV6332FBA 40 페이지.
Zanussi ZEV6332FBA에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 사용자 설명서 (40 페이지)

페이지 인쇄

Problem

There is a dark area on the

multiple zone.

The sensor fields become hot.

comes on.

and a number come on.

E6 comes on.

If you cannot find a solution...

If you cannot find a solution to the problem

yourself, contact your dealer or an Authorised

Service Centre. Give the data from the rating

plate. Give also three digit letter code for the

glass ceramic (it is in the corner of the glass

surface) and an error message that comes on.

Installation

WARNING!

Refer to Safety chapters.

Before the installation

Before you install the hob, write down the

information bellow from the rating plate. The

rating plate is on the bottom of the hob.

Serial number ...........................

Built-in hobs

Only use the built-in hobs after you assemble

the hob into correct built-in units and work

surfaces that align to the standards.

Possible cause

It is normal that there is a dark

area on the multiple zone.

The cookware is too large or you

put it too near to the controls.

Automatic Switch Off operates.

The Child Safety Device function

operates.

There is an error in the hob.

The second phase of the power

supply is missing.

Make sure, you operated the hob correctly. If

not the servicing by a service technician or

dealer will not be free of charge, also during the

warranty period. The instructions about the

Service Centre and conditions of guarantee are

in the guarantee booklet.

Connection cable

• The hob is supplied with a connection cable.

• To replace the damaged mains cable use

Put large cookware on the rear

zones if possible.

Deactivate the hob and activate it

again.

Refer to "Daily use" chapter.

Disconnect the hob from the

electrical supply for some time.

Disconnect the fuse from the

electrical system of the house.

Connect it again. If

again, speak to an Authorised

Service Centre.

Check if the hob is correctly con-

nected to the electrical supply.

Remove the fuse, wait one mi-

nute, and insert the fuse again.

the following (or higher) mains cable type:

H05V2V2-F T min 90°C. Speak to your local

Service Centre.

Remedy

comes on