Zanussi ZEV6646XBA 사용자 설명서 - 페이지 12

{카테고리_이름} Zanussi ZEV6646XBA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZEV6646XBA 17 페이지. Hob zev6646xba
Zanussi ZEV6646XBA에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 사용자 설명서 (12 페이지), 사용자 설명서 (16 페이지)

페이지 인쇄

Problem

You cannot activate the outer

ring.

There is a dark area on

the multiple zone.

The sensor fields become hot.

comes on.

and a number come on.

You can hear a constant beep

noise.

comes on.

IF YOU CANNOT FIND A SOLUTION...

If you cannot find a solution to the problem yourself,

contact your dealer or an Authorised Service

Centre. Give the data from the rating plate. Give

also three digit letter code for the glass ceramic (it

is in the corner of the glass surface) and an error

message that comes on. Make sure, you operated

Possible cause

The highest heat setting is set.

You decreased the heat setting

to 0.

It is normal that there is a dark

area on the multiple zone.

The cookware is too large or

you put it too near to the con-

trols.

Child Safety Device or Lock

operates.

There is an error in the hob.

The electrical connection is in-

correct.

The second phase of the pow-

er supply is missing.

the hob correctly. If not the servicing by a service

technician or dealer will not be free of charge, also

during the warranty period. The instructions about

the Service Centre and conditions of guarantee are

in the guarantee booklet.

Remedy

The highest heat setting has

the same power as the func-

tion.

Start from 0 and increase the

heat setting.

First, activate the inner ring by

changing the heat setting.

Put large cookware on the rear

zones, if possible.

Refer to "Daily use".

Deactivate the hob and acti-

vate it again after 30 seconds.

comes on again, discon-

nect the hob from the electrical

supply. After 30 seconds, con-

nect the hob again. If the prob-

lem continues, speak to an Au-

thorised Service Centre.

Disconnect the hob from the

electrical supply. Ask a quali-

fied electrician to check the in-

stallation.

Check if the hob is correctly

connected to the electrical

supply. Remove the fuse, wait

one minute, and insert the fuse

again.