Zanussi ZGF 642 지침 책자 - 페이지 13

{카테고리_이름} Zanussi ZGF 642에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGF 642 18 페이지. Zanussi instruction booklet gas hob model zgf 642
Zanussi ZGF 642에 대해서도 마찬가지입니다: 지침 책자 (32 페이지)

페이지 인쇄

Electrical connections

Any electrical work required to install this

hob should be carried out by a qualified

electrician or competent person, in

accordance with the current regulations.

THIS HOB MUST BE EARTHED.

The manufacturer declines any liability

should these safety measures not be

observed.

This hob is designed to be connected to a

240V 50Hz AC electrical supply.

Before switching on, make sure the electricity supply

voltage is the same as that indicated on the hob rating

plate. The rating plate is located on the bottom of the

hob. A copy is attached on the back cover of this

book.

The hob is supplied with a 3 core flexible supply cord

incorporating a 3amp plug fitted. In the event of

having to change the fuse, a 3amp ASTA approved

(BS 1362) fuse must be used.

Should the plug need to be replaced for any reason,

the wires in the mains lead are coloured in

accordance with the following code:

Green and Yellow - Earth

Blue

- Neutral

Brown

- Live

— Connect the green and yellow (earth) wire to

the terminal in the plug which is marked with

the letter 'E' or the earth symbol

coloured green and yellow.

— Connect the blue (neutral) wire to the terminal

in the plug which is marked with the letter 'N'

or coloured black.

— Connect the brown (live) wire to the terminal

in the plug which is marked with the letter 'L'

or coloured red.

Upon completion there must be no cut, or stray

strands of wire present and the cord clamp must be

secure over the outer sheath.

A cut off plug inserted into a 13 amp

socket is a seriuos safety (shock) hazard.

Ensure that the cut off plug is disposed of

safely.

Permanent Connection

In the case of a permanent connection, it is necessary

that you install a double pole switch between the hob

and the electricity supply (mains), with a minimum

gap of 3 mm. between the switch contacts and of a

type suitable for the required load in compliance with

the current electric regulations.

The switch must not break the yellow and green earth

cable at any point.

Ensure that the hob supply cord does not

come into contact with surfaces with

temperatures higher than 50 deg. C.

FO 0390